Cisco Meraki MR20-HW Руководство по установке - Страница 10
Просмотреть онлайн или скачать pdf Руководство по установке для Беспроводная точка доступа Cisco Meraki MR20-HW. Cisco Meraki MR20-HW 15 страниц. Cloud-managed access point
Печатать страницу
Then adjust the MR20-HW to guide the MR20-HW's bottom slot into the cradle's bottom
tab until it clicks into place. Once in place, the MR20-HW should be secured to the cradle
by using one of the included screws in the cradle's bottom tab.
Error! Reference source not found.
Error! Reference source not found.
Error! Reference source not found.
To release the MR20-HW from the mount cradle, first remove the security screw that
secures the MR20-HW to the cradle's bottom tab. While holding the MR20-HW with one
hand, press the cradle's bottom tab upwards, releasing the MR20-HW from the bottom of
the cradle. Then remove the MR20-HW from the cradle's top tab.
Desk or Shelf Mount
The MR20-HW can be placed on a desk or shelf resting on the non-scratch rubber feet.
The mount cradle is not necessary for a desk or shelf installation.
Secure the MR20-HW
Depending on your mounting environment, you may want to secure the MR20-HW to its
mount location. Your MR20-HW can be secured in several ways. If the MR20-HW has
been installed using the mount cradle, it should be secured via security screw (Torx
security screws are included) and/or Kensington lock. If the mount cradle was not used,
the MR20-HW can still be secured using a Kensington lock.
Power the MR20-HW
If mounting to an electrical junction box, feed the Ethernet cable through the cable
access hole in the mount cradle. If mounting to a wall or ceiling, the Ethernet cable will
feed from behind the MR20-HW. The
lists the different powering options and their unique characteristics.
Verify Device Functionality and Test Network Coverage
1. Check LEDs
a. The Power LED should be solid green (or blue, if clients are connected). If it
is flashing blue, the firmware is automatically upgrading and the LED
should turn green when the upgrade is completed (normally within a few
minutes). See the
"Power Source
"LED
Indicators" section for more details. .
Options" section of this document