Cisco Meraki MR45 Руководство по установке - Страница 5

Просмотреть онлайн или скачать pdf Руководство по установке для Беспроводная точка доступа Cisco Meraki MR45. Cisco Meraki MR45 16 страниц.
Также для Cisco Meraki MR45: Руководство по установке (15 страниц)

Печатать страницу

Power Source Options

The MR45 access point can be powered using either the Meraki AC Adapter, PoE Injector (both sold separately), or a

third-party PoE switch.

MR45 access points require 802.3at (PoE+) to function properly and do not support low power mode.

Factory Reset Button

If the button is pressed and held for at least ﬁve seconds and then released, the MR45 will reboot and be restored to its

original factory settings by deleting all conﬁguration information stored on the unit.

LED Indicators and Run Dark Mode

Your MR45 is equipped with a multi-color LED light on the front of the unit to convey information about system

functionality and performance:

• Orange - AP is booting (permanent Orange suggests hardware issue)

• Rainbow - AP is initializing/scanning

• Blinking Blue - AP is upgrading

• Green - AP in Gateway mode with no clients

• Blue - AP in Gateway mode with clients

• Blinking Orange - AP can't find uplink

NOTE: Blinking Green LED indicates that the device is in site survey mode. Please see the Conducting Site Surveys

with MR Access Points for more details.

The MR45 may be operated in "Run Dark" mode for additional security and to reduce the visibility of the access point. In

this mode, the LED will not be illuminated. This mode may be enabled through Meraki dashboard.

Pre-Install Preparation

You should complete the following steps before going on-site to perform an installation.

Conﬁgure Your Network in Dashboard

The following is a brief overview only of the steps required to add an MR45 to your network. For detailed instructions