Epson CX4800 - Stylus Color Inkjet Краткое руководство - Страница 30

Просмотреть онлайн или скачать pdf Краткое руководство для Принтер "все в одном Epson CX4800 - Stylus Color Inkjet. Epson CX4800 - Stylus Color Inkjet 48 страниц. Epson scan icm updater v1.20 (psb.2008.07.001)
Также для Epson CX4800 - Stylus Color Inkjet: Начните здесь Руководство (8 страниц), Технический обзор (6 страниц), Руководство пользователя (18 страниц), Обновление (1 страниц)

Cleaning the Print Head

If your printouts are unexpectedly light or faint, or you notice light or dark bands

across your printout, you may need to clean the print head. This unclogs the

nozzles so they can deliver ink properly. Run a nozzle check as described on

page 29 to see if the print head needs cleaning.

Note:

Print head cleaning uses ink, so clean it only if quality declines and the nozzle check

indicates that the print head needs to be cleaned.

If the red

ink light comes on or flashes, you cannot clean the print head. In this case,

replace the appropriate ink cartridge first; see page 31.

1. Make sure the Epson Stylus CX is on and the

2. Hold down the

flashing. The Epson Stylus CX runs a head cleaning cycle and the P

flashes.

Caution:

Never turn off the Epson Stylus CX while head cleaning is in progress. You may

damage it.

3. When the P

page 29) to verify that the print head is clean.

4. If there are still gaps or lines, or the test patterns are faint, run another

cleaning cycle and check the nozzles again.

Note:

If you don't see any improvement after cleaning the print head four or five times,

turn off the Epson Stylus CX and wait overnight. This lets any dried ink soften. Then

try cleaning the print head again. If quality still does not improve, one of the ink

cartridges may be old or damaged and needs to be replaced; see page 31.

Tip:

If you do not use your Epson Stylus CX often, it is a good idea to print a few pages at

least once a month to maintain good print quality.

Maintaining Your Epson Stylus CX All-in-One

ink button for 3 seconds until the P

light stops flashing, run a nozzle check (as described on

ink light is off.

light starts

light