Cisco Codec C Series Руководство по началу работы - Страница 29
Просмотреть онлайн или скачать pdf Руководство по началу работы для Конференц-система Cisco Codec C Series. Cisco Codec C Series 35 страниц. Telepresence conference system
Также для Cisco Codec C Series: Руководство по началу работы (41 страниц), Руководство пользователя (44 страниц), Руководство по началу работы (32 страниц), Руководство по началу работы (42 страниц), Руководство по началу работы (46 страниц)
Печатать страницу
Cisco TelePresence Systems
GettinG started Guide
Table of contents
Introduction
Web interface
Setting the date, time and location
When setting up your video conference system, you
should check that the date and time settings are correct.
Among other things this information is used to time stamp
messages transmitted to gatekeepers and other network
elements.
If you operate your system using the Touch controller, the
time is shown in the top right corner of the Touch controller
display; if you operate your system using a remote control,
the time and date is shown in the top right corner of the
main display.
Save the new value when you change a setting
Click
ok
to save the change, or
cancel
without saving.
D14639.04 Video Systems Getting Started Guide (TC4.2) | 2011 JULY | © 2011 Cisco Systems, Inc. All rights reserved.
User interfaces
1. Go to the
Configuration
Configuration.
Click on Time.
2. Select your preferred time format in the
drop down list.
3. Select your preferred date format in the
drop down list.
4. Select your time zone in the
5. Click on
NetworkServices
Select Auto,
Manual
to leave
If you select
Manual,
enter the NTP server address in the input field.
If you select Off, you have to enter the time and date
manually using either the Touch controller
Settings > Administrator Settings > Date, Time &
Location) or the remote control and on‑screen menu
system
(Home > Settings > Date and
1
NTP mode:
Auto:
The time is regularly updated using an NTP server. The
NTP server address is automatically obtained from the
network (DHCP).
Manual: The time is regularly updated using an NTP server. You
must manually enter the NTP server address.
Off:
You must set the time manually. The time will not be
updated automatically.
Configuration
Configuration
Appendices
tab and select
Advanced
TimeFormat
DateFormat
Zone
drop down list.
and then on NTP.
or
Off
in the
Mode
drop down list.
1
also click on the
Address
value and
(More >
Time).
29
www.cisco.com