Cisco Telepresence MX800 Руководство по началу работы - Страница 43

Просмотреть онлайн или скачать pdf Руководство по началу работы для Конференц-система Cisco Telepresence MX800. Cisco Telepresence MX800 46 страниц. Wall-mounted mx800 single
Также для Cisco Telepresence MX800: Краткое руководство по эксплуатации (12 страниц), Руководство по установке (16 страниц), Руководство по замене (46 страниц), Руководство по замене (47 страниц), Руководство по установке (30 страниц), Запасные части (24 страниц), Руководство по установке (16 страниц), Краткое справочное руководство (2 страниц), Руководство (45 страниц), Руководство (45 страниц), Краткое справочное руководство (2 страниц), Краткое справочное руководство (2 страниц)

Печатать страницу

Cisco Telepresence MX800 Руководство по началу работы

Cisco TelePresence Video Systems

Contents

SX10 on-screen menu

Settings, Standby

mode and Do Not

Disturb feature

Place

calls

content

D14639.15 Video Systems Getting Started Guide TC7.2, OCTOBER 2014.

Introduction

User interfaces

Camera Control

To gain access to the Settings menu, move cursor to upper

left corner of the screen and press

Then navigate down to Settings and press

Configuration

The Settings shows the basic system information. In addition

on the remote control.

it provides access to the Setup assistant and to restart the

again.

system.

On the Setup assistant you can set the following:

Getting Started Guide

Appendices

• Language: Select a language for the user interface.

•

settings: Change the IPv4 settings, if those have not been

configured by autoprovisionig.

•

Provisioning

settings: Change provisioning settings, if those

have not been configured by autoprovisionig.

•

Test

microphone: If you are using an external microphone,

use this test to adjust its location.

•

Speaker

volume: Set the speaker volume for ring tones

and calls. If you cannot hear the test sound, check that

the volume on you monitor is switched on, and that the

cabeling is correct.

•

Default camera position:

Set the default camera position

for future calls.

•

Test

presentation: Connect your computer to the SX10, and

wait for the icon to change and mirror your computer screen.

Contacts