Argo Misse13DCI Инструкция по эксплуатации - Страница 10

Просмотреть онлайн или скачать pdf Инструкция по эксплуатации для Кондиционер Argo Misse13DCI. Argo Misse13DCI 15 страниц. Room air conditioner with remote condenser

Печатать страницу

ADJUSTING THE AIR FLOW DIRECTION

VERTICAL

Hold the end of the flap and move it up and down to adjust

the vertical air flow.

HORIZONTAL

The horizontal air flow can be adjusted by moving the

vertical blades to the left or right, as indicated in the following

figure.

CAUTION

Set vertical blades to the front position during

COOLING/DRY operation if humidity is high.

If the vertical blades are set to the left-most or right-

most position, condensation will form around the air

outlet and drip off.

OPERATION WITHOUT THE REMOTE

CONTROL UNIT

If you have lost the remote control unit or it has troubles,

follow the steps below.

1. WHEN THE AIR CONDITIONER IS STOPPED

If you want to turn on the air conditioner push the

OPERATION BUTTON to select the COOL mode:

NOTE

The air conditioner will start in HIGH fan speed.

The temperature setting is 25°C.

2. WHEN THE AIR CONDITIONER IS RUNNING

If you want to turn off the air conditioner push the

OPERATION BUTTON until the OPERATION lamp is turned

off.

NOTE

Power failure during operation.

In the event of power failure, the unit will stop. When the

power is resumed, the unit automatically restarts after 3

minutes.

OPERATION BUTTON

CARE AND CLEANING

CAUTION

For safety, be sure to turn the air conditioner off and

also to disconnect the power before cleaning.

OUTDOOR UNIT

(CASING AND CONDENSING COIL)

Some metal edges and the

condenser fins are sharp and may

cause injury if handled improperly;

special care should be taken when

you clean these parts.

Periodically check the outdoor unit

to see if the air outlet or air intake

are clogged up with dirt or soot.

The

condenser

components of the outdoor unit must

be cleaned periodically.

Consult your DEALER or AFTER

SALES SERVICE.

INDOOR UNIT

Do not pour water on the unit to clean it. This will damage

the internal components and cause an electric shock

hazard.

Never use solvents, or chemical agents when cleaning the

indoor unit. Do not wipe the plastic casing using very hot

water.

Casing and Grille

Clean the casing and grille of the indoor unit with a vacuum

cleaner brush, or wipe them with a clean, soft cloth. If these

parts are stained, use a clean cloth moistened with a mild

liquid detergent. When cleaning the grille, be careful not

to force the blades out of place.

and

other