Cisco 2100 Series Краткое руководство по эксплуатации - Страница 15

Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Сетевое оборудование Cisco 2100 Series. Cisco 2100 Series 49 страниц. Cisco 8500 series wireless lan controller
Также для Cisco 2100 Series: Руководство по конфигурации (40 страниц), Руководство по конфигурации (50 страниц), Краткое руководство по эксплуатации (12 страниц)

Table 1

Startup Wizard Information (continued)

Wizard Setting

AP Manager Interface IP Address

Virtual Gateway IP Address

Mobility/RF Group Name

Network Name (SSID)

Allow Static IP Addresses

Action

Enter the IP address of the access point manager

interface.

The AP manager interface manages all Layer 3

communications between the controller and

lightweight access points after the access points

have joined the controller.

Enter the IP address of the controller's virtual

interface. You should enter a fictitious,

unassigned IP address, such as 1.1.1.1.

The virtual interface is used to support mobility

management, DHCP relay, and embedded Layer

3 security such as guest web authentication and

VPN termination. All controllers within a

mobility group must be configured with the same

virtual interface IP address.

If desired, enter the name of the mobility

group/RF group to which you want the controller

to belong.

Although the name that you enter here is assigned

to both the mobility group and the RF group,

these groups are not identical. Both groups define

clusters of controllers, but they have different

purposes. All of the controllers in an RF group

are usually also in the same mobility group and

vice versa. However, a mobility group facilitates

scalable, system-wide mobility and controller

redundancy while an RF group facilitates

scalable, system-wide dynamic RF management.

Enter the network name, or service set identifier

(SSID). This is the default SSID that the access

points use when they join a controller.

Enter YES to allow clients to assign their own IP

address or no to make clients request an IP

address from a DHCP server. The default setting

is YES.