Argo SDIAS8DC Руководство по установке - Страница 11

Просмотреть онлайн или скачать pdf Руководство по установке для Кондиционер Argo SDIAS8DC. Argo SDIAS8DC 19 страниц. Split air conditioner system
Также для Argo SDIAS8DC: Руководство по эксплуатации (15 страниц), Руководство по эксплуатации (17 страниц)

Печатать страницу

10 - REMOTE CONTROL UNIT INSTALLATION

To ensure that the air conditioner operates correctly, DO NOT install the remote control unit in the following places:
•
In direct sunlight.
•
Behind a curtain or other places where it is covered.
•
More than 8 m. away from the air conditioner.
•
In the path of the air conditioner airstream.
•
Where it may become extremely hot or cold.
•
Where it may be subject to electrical or magnetic noise.
•
Where there is an obstacle between the remote control unit and air conditioner.
WALL-MOUNTED POSITION
•
Momentarily place the remote control unit in the desired mounting position.
•
Verify that the remote control signals are received by the unit from the selected position.
•
Fix the support at the wall with two screws and hang the remote control unit.
TABLE STAND
Place the support on a flat surface making sure that the remote control signals are received by the unit from the selected
position.

11 - INFRARED RECEIVER INSTALLATION

Slot a screwdriver by the 2 slits on the cover sides,
A
and separate the cover from the base.
Do not lay the receiver cable near any power lines,
and do not put it into any raceways or metal tubes
together with other power lines. Install the receiver
far from electromagnetic interferences. Always
provide for an earth connection near the receiver
location, where possible.
Perform the earth connection with the terminal on the base, as
C
provided. Complete earth connection and fasten the other end of
the cable to the terminal 3 (COM) TP1 in the electric panel.
Connect the connector of the receiver cable to the pcb as shown
below and in the wiring diagram.
Do not power the system up, and do not start the unit before having
completed the refrigerant piping and the electric installation.
If allowed by the local electric-power standards,
B
standard electric-component boxes can be used
for assembling the receiver.
3 (COM)
11
TABLE
WALL
STAND
SUPPORT
EN