Argo Dream IP21 Руководство по эксплуатации - Страница 6
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Нагреватель Argo Dream IP21. Argo Dream IP21 7 страниц. Ceramic fan heater for bathroom use
Печатать страницу
4. TIMER BUTTON:
with the unit operating it
allows for programming the
switch-off after 1, 2 or 4
hours, by pressing it once,
twice or three times
(repetition sequence)
TIMER LED
Move the switch-on button (on the rear, beneath the air intake grille) to position 'I'. When the appliance emits a beep, this
means that the fan heater is ready for use (stand-by). The
By pressing the
STAND-BY
COMFORT heat level
At this stage it is possible to leave the NORMAL operating mode or select the BODY-SENSOR mode (activation
of the PRESENCE SENSOR): the corresponding LED will light up.
In both the NORMAL and in the BODY-SENSOR modes, it is possible to select the COMFORT mode
(maximum heat 2000 W) or the ECO mode
possible to set the timer for switch-off, after 1, 2 or 4 hours.
When the COMFORT mode is selected, the appliance will first operate for 10" at minimum power before
activating the maximum heat mode.
If the unit is operating and the
before switching off completely, to cool the ceramic heating element.
If the unit has been in stand-by mode for quite some time, so that the heating element has already cooled
down, pressing the ON/OFF button causes the unit to switch off instantly, without ventilating.
In the BODY-SENSOR mode: every 2 minutes the unit detects the presence of people in the room, in the range
of approximately 2 metres. If is does not detect anyone and the ECO or COMFORT modes have been selected,
the heating element switches off but the fan will continue operating for 8 minutes: the unit will then enter the
stand-by mode. If the cold ventilation mode is selected, the fan will continue to operate for 10 minutes before
entering the stand-by mode.
To switch off the fan heater completely, move the on/off button to the "0" position.
V 06/16
CONTROL PANEL
3. OPERATING MODE BUTTON
COMFORT – maximum heat (2000 W)
ECO – minimum heat (1300 W)
ventilation only
(repetition sequence)
OPERATING
MODE LED
button '
', the appliance will start functioning in NORMAL mode, at the
.
button is pressed, the unit will continue to ventilate for a few minutes
STAND-BY
2. SELECTION BUTTON
operation without PRESENCE
SENSOR (NORMAL) or with
PRESENCE SENSOR (BODY-S)
NORMAL or
BODY-SENSOR
MODE LED
STAND-BY
LED is lit.
(minimum heat 1300 W) or cool ventilation
1. STAND-BY BUTTON
STAND-BY
LED
(seq.). It is also
13