Cisco 6160 Руководство по процедурам установки - Страница 25

Просмотреть онлайн или скачать pdf Руководство по процедурам установки для Сетевое оборудование Cisco 6160. Cisco 6160 32 страницы. Without a pots splitter configuration
Также для Cisco 6160: Краткое справочное руководство (38 страниц), Руководство по установке оборудования (21 страниц), Указания по установке и замене (18 страниц)

Chapter 4

Installing a Cisco 6160 Without a POTS Splitter Configuration

Table 4-2

Stop bits

Flow control

Warning

The ports labeled "ENET," "CNSL," and "AUX" are safety extra-low voltage (SELV) circuits. SELV

circuits should be connected only to other SELV circuits. Because the DSL circuits are treated like

telephone-network voltage, avoid connecting the SELV circuit to the telephone network voltage (TNV)

circuits.

4.2.14 Connect the Auxiliary Port

This step is optional.

Note

Connect a terminal, a modem, or another serial device to the RJ-45 auxiliary port (AUX) on the NI-2

card faceplate.

The ports labeled "ENET," "CNSL," and "AUX" are safety extra-low voltage (SELV) circuits. SELV

Warning

circuits should be connected only to other SELV circuits. Because the DSL circuits are treated like

telephone-network voltage, avoid connecting the SELV circuit to the TNV circuits.

Cisco recommends that you label each data cable at both ends to identify its destination.

Tip

When you turn on the Cisco 6160 for the first time, the System Configuration Dialog appears on the

console screen. The System Configuration Dialog guides you through the initial configuration process.

(You can run the dialog at any time by entering the setup command in privileged EXEC mode.)

When you complete the dialog, the system displays the configuration command script that you have

created. It then offers you three options:

[0] Go to the IOS command prompt without saving this config.

[1] Return back to the setup without saving this config.

[2] Save this configuration to nvram and exit.

If you enter 2, the configuration is saved and used. If you answer 0 or 1, the configuration you created is

not saved. Enter 1 if you wish to discard the configuration and restart the System Configuration Dialog.

OL-2190-02 B0

Terminal Settings (continued)

None

Installation Procedures

Cisco 6160 Hardware Installation Guide

4-25