Cisco 7513 Series Краткое руководство по эксплуатации - Страница 40

Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Сетевое оборудование Cisco 7513 Series. Cisco 7513 Series 44 страницы. Chassis replacement
Также для Cisco 7513 Series: Инструкции по замене Руководство (26 страниц), Информационный лист (11 страниц), Руководство (30 страниц), Поддержание (20 страниц), Инструкции по замене Руководство (19 страниц), Инструкции по замене Руководство (22 страниц)

Note

First remove the VIP from the chassis before removing the port adapter from the VIP. See the "Remove

and Install an Interface Processor, Filler, VIP, or RSP" section on page 27 for instructions.

Step 1

Remove the screw that secures the port adapter (or blank port adapter), as shown in A.

Step 2

Grasp the handle and carefully pull it out of its slot, away from the edge connector at the rear of the

slot. (See A.)

Step 3

To insert the port adapter, align the carrier between the upper and the lower edges of the port adapter

slot. (See B.)

Step 4

Carefully slide the port adapter into the slot until the connector is completely seated in the connector

at the rear of the port adapter slot, as shown in B.

Step 5

Install the screw in the rear of the port adapter slot on the VIP. Do not overtighten the screw. (See A.)

Step 6

Carefully slide the VIP motherboard into the interface processor slot until the connectors at the rear

of the VIP are completely seated in the connectors at the rear of the interface processor slot. Use the

ejector levers to seat the VIP in the interface processor slot. Tighten the captive installation screws on

the VIP.

(See C.)