Cisco 7513 Series Поддержание - Страница 4

Просмотреть онлайн или скачать pdf Поддержание для Сетевое оборудование Cisco 7513 Series. Cisco 7513 Series 20 страниц. Chassis replacement
Также для Cisco 7513 Series: Краткое руководство по эксплуатации (44 страниц), Инструкции по замене Руководство (26 страниц), Информационный лист (11 страниц), Руководство (30 страниц), Инструкции по замене Руководство (19 страниц), Инструкции по замене Руководство (22 страниц)

Maintenance Procedures for the Cisco 7513, Cisco 7513-MX, and Cisco 7576

Use a flat-blade screwdriver to loosen the captive screw that secures the power supply to the chassis

Step 3

frame.

Figure 7-1

Grasp the power supply handle and pull the power supply about halfway out of the bay (approximately

Step 4

8 inches [20 cm]); then with your other hand under the power supply, pull it completely out of the bay.

Figure 7-2

Caution

To maintain agency compliance requirements and meet EMI emissions standards in Cisco 7513, Cisco

7513-MX, and Cisco 7576 chassis with a single power supply, a power supply blank must remain in the

power supply bay adjacent to the power supply. Do not remove this blank from the chassis unless you

do so to install a redundant power supply.

To prevent system problems, do not mix AC-input and DC-input power supplies.

Note

High current levels on the power supply connections at the rear of the power supply bay are exposed

Warning

with the power supply or blank removed. Do not insert anything conductive into the open power

supply bay while power is ON.

Cisco 7500 Series Installation and Configuration Guide

7-4

Removing a Power Supply (Cisco 7513, Cisco 7513-MX, and Cisco 7576 AC-Input

Power Supplies Shown)

FAN

OUTPUT

FAIL

FAN

OUTPUT

FAIL

Captive screws

Supporting the Power Supply (Cisco 7513, Cisco 7513-MX, and Cisco 7576 AC-Input

Power Supply Shown)

FAN

OUT PUT

FAI L

Chapter 7

Maintaining Your Cisco 7513, Cisco 7513-MX, and Cisco 7576 Router

POW ER

OL-5008-03 B0