Cisco ACIP-SM= Руководство по установке и настройке - Страница 22
Просмотреть онлайн или скачать pdf Руководство по установке и настройке для Сетевое оборудование Cisco ACIP-SM=. Cisco ACIP-SM= 33 страницы. Atm cable interface processor (acip)
Печатать страницу
Configuring the ACIP
Configure an ACIP Interface
The ACIP interface (or subinterface) uses the configuration defaults shown in Table 1. For
information on how to change the defaults, refer to the "Configuring ATM" chapter of the Wide-Area
Networking Configuration Guide and the "Configuring Interfaces" chapter of the Configuration
Fundamentals Configuration Guide. All ATM and interface commands might not be applicable to
the ACIP interface.
Note
this interface."
Table 1
Parameter
Maximum transmission unit
Exception queue buffers
Receive buffers
Transmit buffers
Maximum number of virtual
circuits (VCs)
ATM raw cell queue size
ATM VCs per VP
Source of Transmit Clock
To configure the ATM interface on the ACIP, perform the following tasks beginning in global
configuration mode:
Task
Step 1
Step 2
Step 3
Step 4
Step 5
1. For more information on creating bridge groups, refer to the "Configuring Transparent Bridging" chapter
of the Bridging and IBM Network Configuration Guide.
2. Because the ACIP contains a single interface, the port number is always 0.
22 ATM Cable Interface Processor (ACIP) Installation and Configuration
If a command is not available, the router displays the message "Command not supported on
ACIP Defaults
Command
mtu bytes
atm exception queue number
atm rxbuff number
atm txbuff number
atm maxvc number
atm rawq-size number
atm vc-per-vp number
atm clock internal
1
Assign a bridge group.
Specify the interface and enter interface
configuration mode.
Assign the bridge group to the interface.
Disable the spanning tree on the interface.
Change the shutdown state to up and enable
the interface.
Default Value
4470
32
256
256
2048
32
1024
Recovered receive clock
Command
bridge bridge-group protocol {dec | ieee}
2
interface atm slot/0
bridge-group number
bridge-group number spanning-disabled
no shutdown