Argo KOBRA 400 ES Руководство по эксплуатации - Страница 11

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Измельчитель бумаги Argo KOBRA 400 ES. Argo KOBRA 400 ES 20 страниц.

WARNING!

Lubrication is an indispensable element ensuring proper, failure-free operation of

the shredders. Failure to comply with this recommendation will void the warranty.

It is recommended to limit jams caused by inserition of excessive quantities of paper and

to operate the machine below its maximum shredding capacity - 70% of the maximum

number of sheets for a given model.

You are adviced to limit jams caused by inserting too much paper and to operate the

machine below maximum capasity in order to prolong th elife of te machanical parts and

the life od the machine itself.

Continous jams may cause breakage of the transmission mechanisms and void the war-

ranty.

Inserting foreign bodies or material may damage the cutting knives and void the warranty.

In the case of destroying floppy disks, each one should be put in a position with one cor-

ner down, placing the deepest in the entrance slot. In case of difficulties with gripping the

disk by cutting blades, it should be pushed with any other material intended for destruc-

tion by the shredder.

Only insert one CD-ROM or DVD at a time.

Kobra 400 HS-COMBI AUTOMATIC OILER comes with a special electronic blocking system

which prevents the use of the two throats (CDs and paper) at the same time.

If they are used together, shredding stops and the machine goes into reverse for a few

seconds. To restart the blades, simply free the two throats and then only insert either

paper od CD.

FAILURE

In the event of a fault, the device together with the warranty card and damage description

should be handed to the seller or the nearest authorized service center.

The device can be forwarded for repair, which is why the user should keep the original and

complete packaging. In case of the device being returned for repair in a non-original or

incomplete packaging, the purchaser bears the risk of damaging the device during trans-

port. Therefore, in the lack of the original packaging, it is in the buyer's interest to make the

best replacement packaging.

The parameters of the shredders, including the amount of destroyed pages are spe-

cified by the manufacturer individually for each model. The occurring discrepancies

in most cases result from a different voltage in the network, different paper weights

or without due care and non-compliance with the operating conditions set out in

this manual. If it happens that the shredder destroys only fewer sheets at a time than

specified by the manufacturer, please first check the actual voltage in the network

corresponds to the voltage set for a given number of destroyed cards and oil the

cutting knife system.