Cisco Aironet 1140 Series Руководство по началу работы - Страница 20

Просмотреть онлайн или скачать pdf Руководство по началу работы для Сетевое оборудование Cisco Aironet 1140 Series. Cisco Aironet 1140 Series 37 страниц. Autonomous access point
Также для Cisco Aironet 1140 Series: Руководство по началу работы (35 страниц), Руководство по конфигурации (40 страниц), Информационный лист (6 страниц), Руководство по началу работы (31 страниц)

Table 2

Access Point LED Diagnostic Messages (continued)

Message Type

Boot loader errors

Cisco IOS errors

Configuring System Power Settings

After connecting the access point to a power source, its status LED might be amber, which can indicate

that the access point is unable to verify that the power source equipment (PSE) is supplying sufficient

power. In such cases, you need to configure settings on the access point or the switch to identify your

power source.

Identify your power source and switch condition, and then make sure that your devices are configured

with an IP address.

Follow these steps to configure the system power settings using the GUI:

Open your browser and enter the access point IP address in the address field. A login and

Step 1

password screen appears.

Enter the username Cisco and password Cisco. The username and password are case sensitive.

Step 2

Step 3

When the access point does not receive enough power for full operations, it is in low power

mode. If your access point is in low power mode, a warning message appears indicating that

all radios are disabled due to insufficient power. Click OK to continue. The System

Configuration page appears.

Scroll down to the System Power Settings section as shown in Figure 4.

Step 4

Status LED

Red

Blinking red and blue

Blinking red and off

Red

Cycling through blue,

green, red, and off

Message Meaning

DRAM memory test failure

FLASH file system failure

Environment variable failure

Bad MAC address

Ethernet failure during image recovery

Boot environment failure

No Cisco image file

Boot failure

Software failure; try disconnecting and

reconnecting unit power

General warning; insufficient inline power