Sony XCI-V100 Техническое руководство - Страница 9
Просмотреть онлайн или скачать pdf Техническое руководство для Цифровая камера Sony XCI-V100. Sony XCI-V100 23 страницы. Intelligent
Печатать страницуConnecting the Camera Cable
Connect the camera cable to the DC IN connector.
Also, if needed, connect the LAN cable to the LAN
connector, the monitor cable to the MONITOR
connector, the serial cable to the SERIAL connector, the
DIGITAL I/O cable to the DIGITAL I/O connector, and
the USB mouse/keyboard to one of the USB connectors
respectively. When you connect the monitor cable or
DIGITAL I/O cable, plug the cable connector into the
monitor connector or DIGITAL I/O connector until they
snap into place, holding them.
Then tighten the fixing screws placed on both sides of
the cable connector.
7 8
90qaqs
1 Monitor cable
2 USB cable
3 LAN cable
4 DIGITAL I/O cable
5 Camera cable
6 Serial cable
Connect the other end of 5 to the power supply.
Also, if needed, connect 1 to the monitor, 3 to the host
device, 4 to the DIGITAL I/O control device, and 6 to
the camera control device.
Note
Looseness of the fixing screws may cause poor
connection and damage the camera module or cables.
Fasten the fixing screws.
Using a Tripod
Use a tripod screw with a protrusion
the installation surface, as follows, and tighten it, using
a screwdriver.
: 4.3 mm to 5 mm (0.17 inches to 0.20 inches)
1
2
3
4
5
6
7 MONITOR connector
8 Hi-speed USB connector
9 LAN connector
0 DIGITAL I/O connector
qa SERIAL connector
qs DC IN connector
extending from
Attaching the Fall-Prevention Wire
Rope
Warning
• If you want to install the camera at a height such as on
a ceiling, entrust the installation to an experienced
contractor or installer.
• If you install the camera at a height, ensure that the
installation location and its material are strong enough to
support the weight, and then install the camera securely.
Insufficient support may cause the camera to fall,
resulting in damage to the camera and severe injuries.
• To prevent the camera from falling, be sure to attach
the supplied wire rope.
• If you install the camera at a height, check
periodically, at least once a year, to ensure that the
connection has not loosened. If conditions warrant,
perform this periodic check more frequently.
1
Attach the fall-prevention wire rope (supplied) to
the camera module, using the supplied screw.
2
Attach the other end of the fall-prevention wire
rope to a junction box, etc. (screw not supplied)
Notes
• The fall-prevention wire rope is very important for fall
prevention. Perform the procedure correctly.
• Use the screws supplied with the XCI-SX100/
SX100C/V100/V100C. Using screws other than those
supplied may cause damage inside the camera
module.
Screw
(supplied)
9