ACU-RITE 745604-NN Обновление программного обеспечения - Страница 6



The helix step requires a tool diameter greater than 0. Check for tool diameter > 0 before running

a helix step and display an error message if necessary.



Corrected a problem with the Custom Pocket cycle sometimes missing an Island.



Fixed an issue where a contour was not properly repeated when the tool diameter is different.



Corrected some issues with the feature to automatically switch the DRO to INC mode at Z-Axis

manual operation prompts.



The Scale Factor field in Job Setup is now checked for a valid range of entry. If a value greater

than "100" or less than "0.1" is entered, the value will automatically revert back to the safety

default of "1". When a Scale Factor other than "1" is active in the system, the Scale status window

at the top of the screen will now highlight this with an alternate background color.



Fixed an issue where the Blend's feed rate was not changed by Change Steps step function.



Corrected an issue in which when setting the Datum, sometimes an error 220-0020 could be

displayed.



Corrected an issue in which the W-Axis coupling settings would be lost when upgrading to R6-

SP3.



Corrected a couple of graphics issues, in which Pan settings would be applied in reverse (horiz

vs. vert), and in which Reset Graphics was resetting too many parameters.



Corrected an issue where the Near Zero Warning Bar would not always be visible in INC mode of

the DRO as it should have been.



Corrected an issue with the Set RPM feature; if a spindle gear change was required, upon

pressing GO to complete the gear change, the system would incorrectly try to start running the

loaded program instead of just completing the RPM change, resulting in an unexpected 'Paused'

state.

If any issues are encountered, please contact your service representative for assistance or

contact technical support at

if you have any questions.