Sony NW-E405 - Network Walkman Player Руководство по эксплуатации - Страница 2

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Стереосистема Sony NW-E405 - Network Walkman Player. Sony NW-E405 - Network Walkman Player 30 страниц. Portable ic audio player
Также для Sony NW-E405 - Network Walkman Player: Краткое руководство по эксплуатации (2 страниц), Технические характеристики (2 страниц), Ограниченная гарантия (1 страниц), Указания по использованию (1 страниц), Указания по использованию (1 страниц), Краткое руководство по эксплуатации (3 страниц)

Печатать страницу
Sony NW-E405 - Network Walkman Player Руководство по эксплуатации
NW-E403/E405/E407

TABLE OF CONTENTS

1.
................................................................... 3
2.
2-1. Disassembly Flow ........................................................... 5
2-2. Lid (Connector) ............................................................... 6
2-3. Cabinet (Inner) ................................................................ 6
2-4. Arm (Shuttle) ................................................................... 7
2-5. Knob (Shuttle) ................................................................. 8
2-6. MAIN Board .................................................................... 9
2-7. Organic EL Indicator Module ......................................... 10
3.
............................................................... 11
4.
4-1. Block Diagram ................................................................ 13
4-9. Printed Wiring Board - SW Board - .............................. 21
5.
5-1. Overall-1 .......................................................................... 24
5-2. Overall-2 .......................................................................... 25
6.
\
2
.................................. 26
Flexible Circuit Board Repairing
• Keep the temperature of the soldering iron around 270 °C
during repairing.
• Do not touch the soldering iron on the same conductor of the
circuit board (within 3 times).
• Be careful not to apply force on the conductor when soldering
or unsoldering.
Notes on chip component replacement
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be
damaged by heat.
Microsoft, Windows and Windows Media are trademarks or
registered trademarks of Microsoft Corporation in the United States
and/or other countries.
US and foreign patents licensed from Dolby Laboratories.
All other trademarks and registered trademarks are trademarks or
registered trademarks of their respective holders.
UNLEADED SOLDER
Boards requiring use of unleaded solder are printed with the lead-
free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come printed with
the lead free mark due to their particular size)
: LEAD FREE MARK
Unleaded solder has the following characteristics.
• Unleaded solder melts at a temperature about 40 °C higher
than ordinary solder.
Ordinary soldering irons can be used but the iron tip has to be
applied to the solder joint for a slightly longer time.
Soldering irons using a temperature regulator should be set to
about 350 °C.
Caution: The printed pattern (copper foil) may peel away if
the heated tip is applied for too long, so be careful!
• Strong viscosity
Unleaded solder is more viscou-s (sticky, less prone to flow)
than ordinary solder so use caution not to let solder bridges
occur such as on IC pins, etc.
• Usable with ordinary solder
It is best to use only unleaded solder but unleaded solder may
also be added to ordinary solder.