Sony PFV-SP3300 Руководство по эксплуатации - Страница 15

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Стереосистема Sony PFV-SP3300. Sony PFV-SP3300 18 страниц. Signal processing unit, backup power supply unit
Также для Sony PFV-SP3300: Руководство по установке (16 страниц), Руководство по эксплуатации (18 страниц), Руководство по техническому обслуживанию (40 страниц)

4 Cover plates

Remove the corresponding plates to install the optional

boards.

5 REF IN (reference input) connectors (BNC type)

The connectors accept two (A and B) analog reference

video signals (black burst signals or tri-level sync

signals for HDTV).

Two connectors of each pair have internal loop-

through connections. If loop-through output signals

are not used, put a 75-ohm terminator on any

connector that is not used.

6 ~AC IN A connector

To supply power to power unit A, connect to an AC

power supply using an appropriate AC power cord.

7 ~AC IN B connector

To supply power to power unit B, connect to an AC

power supply using an appropriate AC power cord.

8 U (signal ground) terminal

For signal ground. Connect to a ground wire as

required.

9 STATUS OUT connector (Mini D-sub 15-pin)

Outputs the statuses of the unit in the same manner as

the front-panel indicators.

For details, refer to the installation manual.

0 REMOTE connector (BNC type)

The connector is an S-BUS connector to be used for

routing switcher control. When a board installed in

this unit requires S-BUS communication with the

PFV-SP3300 main frame, connect an S-BUS control

line to this connector.

5 (E)