Argo 6x6 Conquest Руководство по эксплуатации - Страница 8

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Внедорожник Argo 6x6 Conquest. Argo 6x6 Conquest 16 страниц. Ducting & exhaust

Argo Service Manual

Re-fasten the exhaust manifold to the engine. Torque to specification.

Exhaust manifold gaskets should be replaced with new ones

Assemble the muffler assembly to the exhaust manifold. The original compression

springs may be reused but new hardware is recommended.

When tightening down the hardware between muffler and exhaust manifold, it is

critical not to overtighten the hardware. By no means should the compression spring

become coil bound. Tighten only enough to provide a good seal between muffler and

manifold. Over tightening can cause undue stress at the muffler inlet due to the

twisting and turning of the vehicle under application. Correct tension at the

compression spring allows for movement in this area.

Reinstall the manifold heat shield and lower cover. Use the appropriate hardware as

illustrated in your parts manual.

10. Fasten the muffler and shroud assembly to the lower body at the front wheel well.

The lower rubber mounted support is slotted to provide adjustment for the tailpipe at

the exhaust screen hole. Ensure that the tailpipe does not touch any of the surround-

ing screen area and secure the assembly to the lower body.

Removing the Muffler (Conquest Models)

On Conquest vehicles manufactured from C19686, all 6x6 Conquests and

all 35th anniversary vehicles:

Remove the 4 fasteners securing the heat shield over the muffler. Photo DE-21

Ontario Drive & Gear Limited

PH.(519)- 662-2840 FAX (519)- 662-2421

DE-19

IMPOR

IMPORT T T T T ANT

IMPOR

ANT

IMPOR

ANT

IMPOR

IMPORT T T T T ANT

IMPOR

ANT

IMPOR

ANT

DE-7

Ducting & Exhaust

www.odg.com

DE-20