MILLPWR
SOFTWARE
UPDATE
Version (2 or 3 axis) - The version number was updated to R3SP2.
You can download the software release update from our web site at www.acu-rite.com. If you
wish to purchase the software and operation manual from ACU-RITE contact Customer Service
to place an order.
Installing the software onto your MILLPWR
HEIDENHAIN Corporation recommends making a backup of the control with the included USB
Recovery Drive (684138-xx) before updating the control software. Please refer to the manual
included with the drive for the backup procedure.
Use a blank USB memory stick (1 GB or larger) to update the software. Do not use any memory
stick with a smaller storage capacity. The software installation files are required for updating the
software. These files will automatically be recognized by the installation program of the control
and must be contained in a folder named "install" on the USB memory device with typical files
called setup.zip, and setup.ini.
Procedure for updating the software
Shut down the control software using the normal method of pressing the Shutdown soft
key and then confirming the shutdown by pressing Yes.
Wait for the screen message which indicates that it is safe to switch off power, or restart.
Insert the USB memory device containing the folder named "install" on the USB memory
device.
Press ENTER to restart the system.
After starting, the MILLPWR
box. If necessary, use the UP/DOWN ARROW keys to select the language (e.g. English)
and press ENTER.
A confirmation box will appear. If necessary, use the LEFT or RIGHT ARROW keys to
select Yes, and then press ENTER.
The software update will now be done automatically, taking approximately 10 - 20
minutes.
When the update is complete, it will prompt you to remove the USB drive and restart. At
this time, remove the USB drive and press ENTER to restart.
After the system has restarted, it will start up normally to the control software.
If any issues are encountered, please contact your service representative for assistance.
If the USB memory stick used for installation is not removed, then the prompt to install the
software will continue to appear on subsequent power cycles.
G2
G2
system:
G2
Software Update screen will appear with a confirmation
Печатать страницу