Argo S6999 Руководство по эксплуатации - Страница 13

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Внедорожник Argo S6999. Argo S6999 16 страниц. Ducting & exhaust

Argo S6999 Руководство по эксплуатации
Ducting & Exhaust
2.
Remove the tail pipe assembly by disconnecting the springs from the muffler at-
tached to the tail pipe.
3.
The screen-type spark arrester assembly is located inside the tail pipe. It is fastened
with one (1) slotted washer-head hex screw. Find the screw on the side of the outlet
tube.
4.
Remove the screw and save it for step 9.
5.
Take off the screen-type spark arrester assembly.
6.
Shake loose particles out of the screen assembly.
7.
Clean the screen with a wire brush. (Soak it in oil solvent if necessary.)
8.
If any breaks in the screen or weldments are discovered, replace the assembly.
9.
Return the screen assembly to the outlet tube and refasten it with the screw from
Step 4.
Removing the Intake Duct (Response, Bigfoot, Vanguard2 & Vanguard Models)
1.
Locate the 2 fasteners securing the intake duct to the hood frame assembly and re-
move. There are 2 spacers assembled with the fasteners. Photo DE-29
2.
Undo the fuel line from the nylon clips securing it to the intake duct.
3.
Pull the ducting from the vehicle. Navigate it towards the front of the vehicle pulling
it up, and out. Photo DE-30
6x6 Vanguards manufactured prior to S8131 will have a spring attached at the rear of the
intake and connected to a small molly hook that is riveted to the lower body wheel well.
See the appropriate illustrated parts manual.
Ontario Drive & Gear Limited
PH.(519)- 662-2840 FAX (519)- 662-2421
DE-29
DE-12
Argo Service Manual
DE-30
www.odg.com