Cisco CAB-SM-LCSC-1M Указания по установке - Страница 23
Просмотреть онлайн или скачать pdf Указания по установке для Сетевое оборудование Cisco CAB-SM-LCSC-1M. Cisco CAB-SM-LCSC-1M 42 страницы. Passive optical system
Также для Cisco CAB-SM-LCSC-1M: Указания по установке (36 страниц)
Печатать страницу
Removing the EWDM OADM Module or Booster Amplifier
When performing the following procedures, wear a grounding strap to avoid ESD damage to the OADM
Caution
module.
To remove the OADM module or the multiplexer/demultiplexer module or booster amplifier, follow
these steps:
Step 1
Disconnect all network interface cables from the OADM module or booster amplifier and immediately
install dust plugs in the network interface cable connectors and the OADM connectors.
(Amplifier only) Disconnect the power and ground cables from the booster amplifier.
Step 2
Loosen the captive screw on each side of the OADM module or booster amplifier using a Phillips
Step 3
screwdriver.
Gently pull on both captive screws to release the OADM module or booster amplifier from the two-slot
Step 4
chassis.
Pull the OADM module or booster amplifier out of the two-slot chassis, and place it on an antistatic mat
Step 5
or antistatic foam pad.
Installing and Removing Transceivers
For information on installing, removing, and maintaining the transceivers, refer to:
http://www.cisco.com/en/US/products/hw/modules/ps5455/prod_installation_guides_list.html
Transceivers are static-sensitive devices. Always use an ESD wrist strap or similar individual grounding
Caution
device when handling or coming in contact with transceivers.
To prevent contamination, do not remove the optical bore dust plugs from the transceivers until directed
Note
to do so.
Connecting the EWDM Passive Optical System to Your System
This section is divided into the following topics:
•
•
Use the EWDM passive optical system connector color codes shown in
Note
EWDM passive optical system to your system.
See
78-17894-02
Connecting Cables for a Passive Application, page 25
Connecting Cables for a Boosted Application, page 27
Figures 2
through
5
for the OADM and multiplexer/demultiplexer module front panels.
Cisco Enhanced Wave Division Multiplexing Optical System Installation Note
Connecting the EWDM Passive Optical System to Your System
Table 7
to help you connect the
23