Cisco Catalyst 2960-XR Руководство по началу работы - Страница 9

Просмотреть онлайн или скачать pdf Руководство по началу работы для Сетевое оборудование Cisco Catalyst 2960-XR. Cisco Catalyst 2960-XR 25 страниц.
Также для Cisco Catalyst 2960-XR: Руководство по установке оборудования (34 страниц), Руководство по аппаратному обеспечению (20 страниц)

RJ-45 Console Port

Procedure

Step 1

Connect the supplied RJ-45-to-DB-9 adapter cable to the standard 9-pin serial port on the PC. Connect the other end of

the cable to the console port on the switch.

Step 2

Start a terminal-emulation program on the PC.

Step 3

Configure the PC terminal emulation software for 9600 baud, 8 data bits, no parity, 1 stop bit, and no flow control.

Step 4

Use the CLI to enter commands to configure the switch.

Switch Ethernet Management Port

Procedure

Step 1

Connect a Category 5 Ethernet cable to the PC Ethernet port. Connect the other end of the cable to the Ethernet management

port on the switch.

Step 2

Start a Telnet session on the PC.

Step 3

Enter the switch IP address that you assigned by using Express Setup.

Step 4

Use the CLI to enter commands to configure the switch.

Switch USB Mini-Type B Console Port

Procedure

Step 1

Connect an USB cable to the PC USB port. Connect the other end of the cable to the mini B (5-pin-connector) USB port

on the switch.

Step 2

Start a terminal-emulation program on the PC.

Step 3

Configure the PC terminal emulation software for 9600 baud, 8 data bits, no parity, 1 stop bit, and no flow control.

Step 4

Use the CLI to enter commands to configure the switch. See the software configuration guide and the command reference

for more information.

You cannot use the RJ-45 console port and the USB console port at the same time. The USB console port takes

Note

precedence over the RJ-45 port when both are connected.