8
In Case of Difficulty
If you experience difficulty, help is available in this section and also on Cisco.com. This section
includes Express Setup troubleshooting, how to reset the switch, how to access help online, and where
to find more information.
Troubleshooting Express Setup
If Express Setup does not run, or if the Express Setup page does not appear in your browser:
• Did you verify that POST successfully ran
before starting Express Setup?
• Did you press the Mode button while the
switch was still running POST?
• Did you try to continue without confirming
that the switch was in Express Setup mode?
• Does your PC have a static IP address?
• Did you connect the Ethernet cable to the
console port instead of to a 10/100/1000
Ethernet port or the 10/100 Ethernet
management port on the switch?
• Did you wait 30 seconds after you connected
the switch and the PC before you entered the
IP address in your browser?
• Did you enter the wrong address in the
browser, or is there an error message?
22
If not, make sure that only the SYST and STAT
LEDs are green before pressing the Mode button
to enter the Express Setup mode.
If yes, wait until POST completes. Power cycle the
switch. Wait until POST completes. Confirm that
the SYST and STAT LEDs are green. Press the
Mode button to enter Express Setup mode.
Verify that all LEDs above the Mode button are
green. (The RPS LED is off.) If necessary, press
the Mode button to enter Express Setup mode.
If yes, change your PC settings to temporarily use
DHCP before connecting to the switch.
If yes, disconnect the cable from the console port.
Then connect the cable to an Ethernet port on the
switch and on the PC. Wait 30 seconds before you
enter 10.0.0.1 in the browser.
If not, wait 30 seconds, re-enter 10.0.0.1 in the
browser, and press Enter.
If yes, re-enter 10.0.0.1 in the browser, and press
Enter.
Печатать страницу