Cisco Firepower 4150 Руководство по техническому обслуживанию и модернизации - Страница 17
Просмотреть онлайн или скачать pdf Руководство по техническому обслуживанию и модернизации для Сетевое оборудование Cisco Firepower 4150. Cisco Firepower 4150 20 страниц. Rack-mount and ground the chassis
Также для Cisco Firepower 4150: Руководство (36 страниц), Руководство (26 страниц), Руководство (8 страниц), Руководство (42 страниц), Начало работы (42 страниц)
Печатать страницу
Maintenance and Upgrade
Step 1
Attach the clamp to the tie wrap by holding the clamp with the loop side on the bottom and sliding the tie wrap through
the box-shaped channel above the clamp (see the following figure).
One side of the tie wrap has evenly spaced ridges and the other is smooth. Be sure the ridged side is face up and that you
slide it through the open side of the channel. You will hear a click as the tie slides through—it moves in one direction
only. To remove the tie wrap from the clamp, push the lever on the closed side of the box-shaped channel and slide out
the tie wrap.
Figure 11: Tie Wrap Through the Box Channel of the Clamp
1
Box channel
Step 2
Attach the clamp to the power supply module:
a) Locate the hexagonal ventilation hole on the power supply module at the center of the plug just below the power
connector body (see the following figures).
b) Plug the snapping portion of the tie wrap into the hexagonal hole.
c) With the clamp side facing up, push the tie wrap in until it is fully engaged.
Caution
Make sure you have the correct location because you cannot remove the tie wrap from the power supply
module once you have installed it without damaging the tie wrap.
The black tie wrap is used with the Flextronics power supply module and the off-white tie wrap is used
with the Artesyn power supply module. The black clamp works with both. See the figures below.
Secure the Power Cord on the AC Power Supply Module
2
Tie wrap
Maintenance and Upgrade
17