Cisco IAD2430 Series Краткое руководство по эксплуатации - Страница 29
Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Сетевое оборудование Cisco IAD2430 Series. Cisco IAD2430 Series 34 страницы. Integrated access device
Также для Cisco IAD2430 Series: Обзорное руководство (13 страниц), Обзор (16 страниц)
Печатать страницу
You are now in privileged EXEC mode.
You must change the username and password before you log off the router. You cannot use the username cisco
Note
or password cisco after you log off from this session.
To change the username and password, enter the following at the prompt:
Step 5
username username privilege 15 secret 0 password
Username and password are the username and password that you wish to use.
Use the copy running-config startup-config command at the privileged EXEC mode prompt (
Note
the configuration to NVRAM.
Verify the initial configuration. See the "Verifying and Saving Your Configuration" section on page 33.
Step 6
Setup Command Facility
The setup command facility guides you through the configuration process by prompting you for the specific information that is
needed to configure your system. Use the setup command facility to configure a hostname for the router, to set passwords, and
to configure an interface for communication with the management network.
To use the setup command facility, you will need to establish a console connection with the router and enter privileged EXEC
mode.
To configure the initial router settings by using the setup command facility, follow these steps:
Step 1
Establish a console connection to your router and enter privileged EXEC mode. For instructions on how to enter
privileged EXEC mode see Step 1 through Step 4 in the "Cisco IOS CLI" section on page 28.
In privileged EXEC mode, at the prompt, enter setup.
Step 2
yourname# setup
The following message is displayed:
--- System Configuration Dialog ---
Continue with configuration dialog? [yes/no]:
You are now in setup command facility.
The prompts in the setup command facility vary, depending on your router model, on the installed interface modules,
and on the software image. The following steps and the user entries (in bold) are shown as examples only.
If you make a mistake while using the setup command facility, you can exit and run the setup command facility
Note
again. Press Ctrl-C, and enter the setup command at the privileged EXEC mode prompt (
To proceed using the setup command facility, enter yes:
Step 3
Continue with configuration dialog? [yes/no]: yes
Step 4
When the following messages appear, enter yes to enter basic management setup:
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Basic management setup configures only enough connectivity
for management of the system, extended setup will ask you
) to save
Router#
).
Router#
29