argon audio tt-2 Руководство пользователя - Страница 6

Просмотреть онлайн или скачать pdf Руководство пользователя для Проигрыватель argon audio tt-2. argon audio tt-2 12 страниц.
Также для argon audio tt-2: Руководство пользователя (12 страниц), Руководство пользователя (12 страниц)

TT- 2

Setup and usage

In order to achieve maximum performance and reliability with this record player you should study these instructions for use

carefully.

The Argon Audio TT2 record player is supplied with a factory fitted and adjusted cartridge.

During assembly and adjustment of the deck, small parts could be lost if not carefully placed in a suitable receptacle.

Before starting assembly make yourself acquainted with the parts listed above and correspondingly numbered in the technical

drawings above.

Set-up

Make sure the surface you wish to use the turntable on is level (use a spirit level) before placing the turntable on it.

Fit the drive belt (2/22) around the hub (2/22) and the smaller diameter part of the motor pulley (2/22). Avoid getting sweat or

grease on the belt as these will deteriorate the performance and reduce the belt's lifespan. Use absorbent kitchen paper to

remove any oil or grease from the outer edge of the hub and the belt. Fit the platter (3) and felt mat over the spindle of the hub

(2/22).

Adjusting the down force and anti-skating if you are not familiar with it can be complicated. We recommend that you watch the

following video for your convenience.

YouTube video for adjusting down force and anti skating on a turntable (click here).

The counterweight (4) supplied is suitable for cartridges weighing between 3,5 - 5,5g. An alternative counterweight for cartridges

weighing between 6 - 9g is available as an accessory part. Adjust the down force prior to installing the anti-skating weight.

Gently push and turn the counterweight (4) onto the arm tube stub. Lower the arm lift and position the cartridge in the space between

arm rest and platter. Carefully rotate the counterweight (4) until the arm tube balances out. The arm should return to the balanced

position if it is moved up or down. This adjustment must be done carefully. Do not forget to remove the cartridge protection cap if

fitted.

Once the arm is correctly balanced return it to the rest. Hold the counterweight (4) without moving it, and gently revolve the down

force scale ring (4a) until the zero is in line with the anti-skating prong (8). Check whether the arm still balances out.

Rotate the counterweight counter clockwise (seen from the front) to adjust the down force according to the cartridge

manufacturer's recommendations.

One mark on the scale represents 1 mN (= 0,1g / 0,1 Pond) of downforce.

The recommended downforce for the factory fitted cartridge is 17,5mN

w w w . a r g o n a u d i o . c o m