Epson XP-446 Начните здесь - Страница 2

Просмотреть онлайн или скачать pdf Начните здесь для Принтер "все в одном Epson XP-446. Epson XP-446 4 страницы.
Также для Epson XP-446: Краткое руководство (17 страниц)

Печатать страницу
Epson XP-446 Начните здесь
4
Remove only the yellow tape from each ink cartridge.
Caution:
Do not remove any other labels or seals, or ink will leak.
Do not touch the green chip on the cartridge.
5
Insert the cartridge in the holder for each color. Press each
cartridge down until it clicks. Make sure all cartridges are
pushed down into place.
6
Lower the scanner unit, then press
ink delivery system.
7
The printer starts charging the ink. Ink charging takes
approximately 4 minutes. When you see a completion
message on the printer's LCD screen, charging is complete.
Caution:
Don't turn off the printer while it is charging or you'll
waste ink.
Note:
• The printer is designed for use with Epson
third-party cartridges or ink.
• The cartridges included with the printer are designed for printer
setup and not for resale. After some ink is used for charging, the
rest is available for printing.
4

Load paper

1
Make sure the product is done charging ink. Then fl ip the
feeder guard forward, raise the paper support, and tilt it
backwards slightly.
to start charging the
cartridges only, not
®
2
Slide the edge guide to the left.
3
Slide out the output tray.
4
Load paper, glossy or printable side up and short edge fi rst,
against the right side of the rear paper feed slot.
5
Slide the edge guide against the paper, but not too tightly,
and fl ip the feeder guard back.
Note:
Make sure you place the paper against the right side of the
rear paper feed slot. Otherwise, the printer cannot detect the paper
and the paper setup screen is not displayed on the control panel.
6
Check the current paper settings on the control panel.
To use these settings, press OK. If you want to change the
settings, press
or
Select the paper size, press OK, select the paper type,
press OK, then press OK again to confi rm settings.
to select Change, then press OK.