Cisco RSP7000 Установка - Страница 14

Просмотреть онлайн или скачать pdf Установка для Сетевое оборудование Cisco RSP7000. Cisco RSP7000 26 страниц. Upgrade kit in the cisco 7000 series routers
Также для Cisco RSP7000: Руководство по установке и настройке (48 страниц)

Печатать страницу

Installation Prerequisites

Step 8

Downloading (Retrieving) the Conﬁguration File

After you install the new RSP7000, you can retrieve the saved conﬁguration and copy it to NVRAM.

To retrieve the conﬁguration, enter conﬁguration mode and specify that you will conﬁgure the router

from the network. The system prompts you for a host name and address, the name of the

conﬁguration ﬁle stored on the host, and conﬁrmation to reboot using the remote ﬁle.

You can access the router through a console terminal attached directly to the RSP7000 console port,

or you can conﬁgure an interface port and Telnet to the router from a remote terminal.

Follow these steps to download (retrieve) the currently running conﬁguration from a remote host:

Step 1

Note

conﬁguration in NVRAM. Therefore, any passwords that were conﬁgured on the previous system

will not be valid until you retrieve the conﬁguration.

Step 2

Step 3

Step 4

Step 5

14 Installing the RSP7000 Upgrade Kit in the Cisco 7000 Series Routers

If the display indicates that the process was successful (with the series of ! ! ! and [ok]), the

upload process is complete. The conﬁguration is safely stored in the temporary ﬁle on the

remote ﬁle server.

If the display indicates that the process failed (with the series of . . . as shown in the

following example):

Writing Router-confg .....

your conﬁguration was not saved. Repeat the preceding steps, or select a different remote

ﬁle server and repeat the preceding steps.

After you upload the conﬁguration ﬁle, proceed to "Removing the RP" on page 17. If you

are unable to copy the conﬁguration to a remote host successfully, contact your network

administrator or refer to the end of this document for instructions on contacting technical

assistance.

On the console terminal, the system prompt should display a pound sign (#) to indicate the

privileged level of the EXEC command interpreter. If it does not, enter enable, and then

your password, to get to the privileged level of the EXEC command interpreter.

Until you retrieve the previous conﬁguration, the router will be running from the default

Use the ping command to verify the connection between the router and the remote host.

At the system prompt, issue the conﬁgure network (or copy tftp startup-conﬁg)

command and press Return to enter the conﬁguration mode and specify that you will

conﬁgure the system from a network device (instead of from the console terminal, which

is the default).

Router# configure network

The system will ask you to select a host or network conﬁguration ﬁle. The default is host;

press Return to accept the default.

Host or network configuration file [host]?

The system prompts you for the interface processor address of the host. Enter the interface

processor address or name of the remote host (the remote ﬁle server to which you uploaded

the conﬁguration ﬁle.

IP address of remote host [255.255.255.255]? 1.1.1.1