Cisco RSP7000 Установка - Страница 19

Просмотреть онлайн или скачать pdf Установка для Сетевое оборудование Cisco RSP7000. Cisco RSP7000 26 страниц. Upgrade kit in the cisco 7000 series routers
Также для Cisco RSP7000: Руководство по установке и настройке (48 страниц)

Печатать страницу

Step 2

Step 3

Step 4

Step 5

This completes the RSP7000CI installation procedure.

Removing the SP (or SSP)

Follow these steps to remove the SP (or SSP):

Caution

system component. Removing an SP (or SSP) while the system is operating will cause the system to

shut down or crash and might damage or destroy memory ﬁles.

Step 1

Step 2

Step 3

Step 4

Step 5

Step 6

This completes the SP (or SSP) removal procedure.

Place the back of the RSP7000CI in the 7000 CI slot, and align the notches along the edge

of the carrier with the grooves in the slot. (See Figure 5a on page 9.)

While keeping the RSP7000CI parallel to the backplane, carefully slide the carrier into the

7000 CI slot until the RSP7000CI faceplate makes contact with the ejector levers, then

stop. (See Figure 5b on page 9.)

Using the thumb and foreﬁnger of each hand to pinch each ejector, simultaneously push

both ejectors inward (toward the handle) until they parallel to the faceplate. (See Figure 5c

on page 9.)

Use a screwdriver (number 2 Phillips or 3/16-inch ﬂat-blade) to tighten the captive

installation screws on the ends of the RSP7000CI. (See Figure 5a on page 9.)

Tighten the two captive screws on the RSP7000CI faceplate to prevent the RSP7000CI

from becoming partially dislodged from the backplane and to ensure proper EMI shielding.

(These screws must be tightened to meet EMI speciﬁcations.)

You must shut down the system before removing the SP (or SSP), which is a required

Slip on an antistatic strap and connect the equipment end of the strap to a captive

installation screw on an installed interface processor, or to any unﬁnished chassis surface.

Locate the SP (or SSP) in the your chassis. The SP (or SSP) is installed in slot 5 in the Cisco

7000 or slot 3 in the Cisco 7010.

Use a screwdriver (number 2 Phillips or 3/16-inch ﬂat-blade) to loosen the two captive

installation screws on the SP (or SSP). (See Figure 5a on page 9.)

Place your thumbs on the ends of each of the ejectors and simultaneously pull them both

outward, away from the carrier handle (in the direction shown in Figure 5c on page 9) to

release the carrier from the slot and to dislodge the RP from the backplane.

Grasp the handle with one hand and pull the RP straight out of the slot, keeping your other

hand under the carrier to guide it. (See Figure 6 or Figure 7, depending on your chassis

model.) Keep the carrier parallel to the backplane. Avoid touching the board or any

connector pins.

Place the removed SP (or SSP) on an antistatic mat or foam. If you plan to return the board

to the factory, immediately place it in an antistatic bag to prevent ESD damage.

Installing the RSP7000 Upgrade Kit in the Cisco 7000 Series Routers

Installing the RSP7000 Upgrade Kit