Cisco Secure Firewall Management Center 2700 Руководство по началу работы - Страница 9

Просмотреть онлайн или скачать pdf Руководство по началу работы для Сетевое оборудование Cisco Secure Firewall Management Center 2700. Cisco Secure Firewall Management Center 2700 22 страницы.

Печатать страницу

About the Secure Firewall Management Center 1700, 2700, and 4700

Procedure

Step 1

for the admin account. The password is case-sensitive.

Step 2

When prompted, press Enter to display the End User License Agreement (EULA).

Step 3

Review the EULA. When prompted, enter yes, YES, or press Enter to accept the EULA.

Important

Step 4

To ensure system security and privacy, the first time you log in to the management center you are required

to change the admin password. When the system prompts for a new password, enter a new password complying

with the restrictions, and enter the same password again when the system prompts for confirmation.

Note

Step 5

Configure the network settings.

When you follow the prompts, your options appear in parentheses such as (y/n). Defaults are listed in square

brackets such as [y]. Note the following when responding to the prompts:

• If you are setting up an appliance after restoring it to factory defaults and you did not delete the appliance's

license and network settings, the prompts are prepopulated with the retained values.

• Press Enter to accept the default.

• For hostname, enter a fully qualified domain name (

required.

• If you use DHCP, you must use DHCP reservation, so the assigned address does not change. If the DHCP

address changes, device registration will fail because the management center network configuration gets

out of sync. To recover from a DHCP address change, connect to the management center (using the

hostname or the new IP address) and navigate to System ( ) > Configuration > Management Interfaces

to reset the network.

• Connect a USB keyboard and VGA monitor to the management center for console access.

• Connect a local computer to the management center serial port with an RJ-45 to DP-9 console cable.

• After configuring the IP using the above two methods, access the device using SSH to connect to

the management center using the IPv4 management IP address.

You cannot proceed without accepting the EULA. If you respond with anything other than yes,

YES, or Enter, the system logs you out.

The management center compares your password against a password cracking dictionary that

checks not only for many English dictionary words but also other character strings that could be

easily cracked with common password hacking techniques. For example, the initial configuration

script may reject passwords such as "abcdefg" or "passw0rd."

On completion of the initial configuration process, the system sets the passwords for the two

admin accounts (one for web access and the other for CLI access) to the same value, complying

with the strong password requirements described in the

Administration

Guide. If you change the password for either admin account thereafter, they are

no longer be the same. You can remove the strong password requirement from the web interface

admin account.

Cisco Secure Firewall Management Center 1700, 2700, and 4700 Getting Started Guide

Perform Initial Setup of the Management Center Using the CLI

Cisco Secure Firewall Management Center

) or host name. This field is