Cisco TelePresence Server 7010 Инструкции по замене Руководство - Страница 13

Просмотреть онлайн или скачать pdf Инструкции по замене Руководство для Сетевое оборудование Cisco TelePresence Server 7010. Cisco TelePresence Server 7010 23 страницы. 600w ac-input power supply and fan tray replacement
Также для Cisco TelePresence Server 7010: Руководство по установке (15 страниц), Руководство по установке (14 страниц), Начало работы (16 страниц), Инструкции по замене Руководство (18 страниц)

Figure 7

Cable Management Brackets—Cisco 7010 Shown

Follow these steps to install the two cable management brackets on the new chassis:

If you have new brackets to install on the new chassis, proceed to Step 4. If you are

Step 1

removing the brackets from the old chassis, proceed to the next step.

Step 2

At the interface processor end of the existing chassis, push the cables out of the cutouts in

the brackets. The brackets are ﬂexible and allow cables to pass through the access slots;

however, bending them at extreme angles can cause them to break.

Use a number 1 Phillips screwdriver to remove the six panhead screws (three per bracket)

Step 3

that secure brackets to the inner side of the chassis. You might need to disconnect some of

the interface cables to access the screws. If so, label the cables with their slot/port location,

or reconnect them immediately after removing the bracket.

At the interface processor end of the new chassis, place a bracket on one of the inner sides

Step 4

of the chassis and align the three holes in the bracket with the holes in the chassis.

Insert and ﬁnger-tighten three M3 Phillips screws from the inner side of the chassis,

Step 5

through the bracket and into the chassis. (See Figure 7.)

Step 6

When all three screws are inserted, use the number 1 Phillips screwdriver to tighten the

screws.

Step 7

Repeat Steps 4 through 6 for the second bracket.

Step 8

When connecting the network interface cables or installing processor modules with the

interface cables attached, route the cables through the cable management brackets as shown

in Figure 7. If you are using very thin cables that slip through the bracket openings, insert

cable ties through the holes in the bracket and wrap them around the cables to secure them.

This completes the cable management bracket installation. Proceed to the next section to move the

processor modules to the new chassis.

Cisco 7010 and Cisco 7505 Chassis Replacement Instructions

Replacing the Chassis