Cisco TelePresence Server 7010 Руководство по установке - Страница 5

Просмотреть онлайн или скачать pdf Руководство по установке для Сетевое оборудование Cisco TelePresence Server 7010. Cisco TelePresence Server 7010 15 страниц. 600w ac-input power supply and fan tray replacement
Также для Cisco TelePresence Server 7010: Инструкции по замене Руководство (23 страниц), Руководство по установке (14 страниц), Начало работы (16 страниц), Инструкции по замене Руководство (18 страниц)

Equipment Racks Considerations

The rack-mounting hardware included with the router is suitable for most 19-inch equipment racks

or Telco-type racks. The chassis mounts to two posts or rails in the rack with two mounting ears,

which attach to the sides of the chassis. Ideally, you should be able to access both ends of the router

without having to remove it from the rack.

Before using a particular rack, check for obstructions (such as a power strip) that could impair access

to the interface processors or chassis cover panel. As an alternative, you can install an equipment

shelf in the rack, provided that the rack dimensions allow the router to be secured to the shelf and

the overall conﬁguration permits safe installation and access.

Figure 2 shows the chassis footprint and outer dimensions and the additional clearance required to

remove or install components. All are representative of both the Cisco 7010 and Cisco 7505 chassis.

Rack Dimensions

To use the rack-mounting hardware provided with the router, consider the following guidelines:

•

To mount the chassis between two posts or rails using the mounting ears, the inner clearance (the

width between the inner sides of the two posts or rails) must be at least 17.72 inches (45 cm).

•

The height of the chassis is 11 inches (27.94 cm) with the chassis feet attached, and 10.5 inches

(26.67 cm) when the chassis feet are removed.

Figure 2

Chassis Footprint and Outer Dimensions

14.25 in. (36.20 cm)

2 in.

Power supply width

(5.08 cm)

14.60 in. to ears (37.08 cm)

Noninterface processor end

Interface processor end

Interface processor width

14.55 in. (36.96 cm)

17.50 in. (44.45 cm)

Cisco 7010 and Cisco 7505 Rack-Mount and Cable Management Kits Installation Instructions

Chassis foot C

Chassis width

Prerequisites

1.25 in. (3.18 cm)