Cisco TelePresence Server 7010 Инструкции по замене Руководство - Страница 12

Просмотреть онлайн или скачать pdf Инструкции по замене Руководство для Сетевое оборудование Cisco TelePresence Server 7010. Cisco TelePresence Server 7010 18 страниц. 600w ac-input power supply and fan tray replacement
Также для Cisco TelePresence Server 7010: Инструкции по замене Руководство (23 страниц), Руководство по установке (15 страниц), Руководство по установке (14 страниц), Начало работы (16 страниц)

Replacing Components

Figure 7

Step 9

Step 10

This completes the fan tray removal and replacement procedure.

Proceed to the section "Checking the Installation" on page 16 to restart the system and check the

installation.

Removing and Replacing the Power Supply

You must remove the power harness cover and disconnect the power harness from the backplane

receptacle before you can remove the power supply. A single M3 Phillips screw secures the power

harness cover to the backplane cover. To remove the power supply, you will remove the two M4

Phillips screws that secure the power supply ears to the chassis frame.

Warning

cable to prevent injury. When the power is on, high current is exposed on the fan tray and backplane.

12 600W AC-Input Power Supply and Fan Tray Replacement Instructions

Fan Tray Tracks and Guides

L-bracket

Card cage

Follow Steps 3 through 6 in "Removing and Replacing the Chassis Cover Panel" on page 9

to replace the cover panel.

Ensure that the power switch on the interface processor end of the power supply is in the

off (O) position, then reconnect the power cable to the AC receptacle (if disconnected).

Before accessing the chassis interior, turn off the system power and unplug the power

Fan tray,

side view

Chassis

enclosure

Fan tray,

side view

Bottom runner

Track