Epson 3490 - Perfection Photo Scanner Важные инструкции по безопасности - Страница 2

■

Unplug the scanner and the AC adapter, and refer servicing to qualified service personnel

under the following conditions: The power cord or plug is damaged; liquid has entered the

scanner or the AC adapter; the scanner or the AC adapter has been dropped or the case

damaged; the scanner or the AC adapter does not operate normally or exhibits a distinct change

in performance. (Do not adjust controls that are not covered by the operating instructions.)

■

If you are not going to use the scanner for a long period, be sure to unplug the AC adapter from

the electrical outlet.

■

The lamp in this product contains mercury. Dispose of according to local, state or federal laws.

FCC Compliance Statement

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses, and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio or television reception. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause interference to

radio and television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or more of the following measures:

■

Reorient or relocate the receiving antenna.

■

Increase the separation between the equipment and receiver.

■

Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

■

Consult the dealer or an experienced radio/TV technician for help.

WARNING: The connection of a non-shielded equipment interface cable to this equipment will

invalidate the FCC Certification of this device and may cause interference levels which exceed the

limits established by the FCC for this equipment. It is the responsibility of the user to obtain and

use a shielded equipment interface cable with this device. If this equipment has more than one

interface connector, do not leave cables connected to unused interfaces. Changes or modifications

not expressly approved by the manufacturer could void the user's authority to operate the

equipment.

This Class B digital apparatus meets all requirements of the Canadian Interference-Causing

Equipment Regulations.

Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le materiel brouilleur

du Canada.