Epson 4180 - Perfection Photo Важные инструкции по безопасности

Notices

Important Safety Instructions

Read all of these instructions and save them for later reference. Follow all warnings and instructions

marked on the scanner.

Caution: Be sure the AC power cord meets the relevant local safety standards.

■

Place the scanner close enough to the computer for the interface cable to reach it easily. Do not

place or store the scanner or the AC adapter outdoors, on an unstable surface, near excessive

dirt or dust, water, heat sources, or in locations subject to shocks, vibrations, high temperature

or humidity, direct sunlight, strong light sources, or rapid changes in temperature or humidity.

Do not use with wet hands.

■

When connecting this product to a computer or other device with a cable, ensure the correct

orientation of the connectors. Each connector has only one correct orientation. Inserting a

connector in the wrong orientation may damage both devices connected by the cable.

■

Place the scanner and the AC adapter near an electrical outlet where the power cord can be

easily unplugged.

■

Power supply cords should be placed to avoid abrasions, cuts, fraying, crimping and kinking.

Do not place objects on top of the power cord or allow the AC adapter or power cord to be

stepped on or run over. Be particularly careful to keep all power-supply cords straight at the

ends and the points where they enter and leave the AC adapter.

■

Use only the AC adapter model A311B/E that came with your scanner. Using any other

adapter could cause fire, electrical shock, or injury.

■

The AC adapter is designed for use with the scanner with which it was included. Do not

attempt to use it with other electronic devices unless specified.

■

Use only the type of power source indicated on the AC adapter's label, and always supply

power directly from a standard domestic electrical outlet with the AC power cord that meets

the relevant local safety standards.

■

Avoid using outlets on the same circuit as photocopiers or air control systems that regularly

switch on and off.

■

If you use an extension cord with the scanner, make sure the total ampere rating of the devices

plugged into the extension cord does not exceed the cord's ampere rating. Also, make sure the

total ampere rating of all devices plugged into the wall outlet does not exceed the wall outlet's

ampere rating. Do not place multiple loads on the electrical outlet.

■

Never disassemble, modify, or attempt to repair the AC adapter, scanner, film adapter, or

power cord.

■

Do not insert objects into any opening as they may touch dangerous voltage points or short out

parts. Beware of electrical shock hazards.