Cisco 7513 Series Инструкции по замене Руководство - Страница 2

Просмотреть онлайн или скачать pdf Инструкции по замене Руководство для Сервер Cisco 7513 Series. Cisco 7513 Series 26 страниц. Chassis replacement
Также для Cisco 7513 Series: Краткое руководство по эксплуатации (44 страниц), Информационный лист (11 страниц), Руководство (30 страниц), Поддержание (20 страниц), Инструкции по замене Руководство (19 страниц), Инструкции по замене Руководство (22 страниц)

Product Overview

Caution

section on page 7. The speciﬁc procedures for removing and installing the card cage and backplane

assembly might require two people to perform.

Product Overview

The Cisco 7513, Cisco 7513-MX, and Cisco 7576 card cage holds the processor modules used by

the system. Figure 1 shows the rear view of the system.

The card cage and backplane are one assembly. The Cisco 7513 and Cisco 7513-MX include the card

cage, backplane, dual arbiter, chassis interface, and the electrically erasable programmable

read-only memory (EEPROM) device that contains the system MAC addresses. The dual arbiter and

chassis interface are printed circuit boards that are attached to the rear of the backplane. The dual

arbiter and chassis interface are replaced when the card cage and backplane assembly is replaced.

The Cisco 7576 is a dual independent router system that includes two dual arbiters, two chassis

interfaces, and two EEPROM devices.

Note

system to retain all of its MAC addresses. You must then install the new EEPROM device on the old

card cage before you return the old card cage to Cisco. This procedure only applies if you are

replacing an equivalent card cage. It does not apply if you are upgrading a Cisco 7513 to a

Cisco 7576.

2 Cisco 7513, Cisco 7513-MX, and Cisco 7576 Card Cage and Backplane Assembly Replacement Instructions

Before replacing the card cage and backplane assembly, read the "Safety Guidelines"

You must transfer the EEPROM device from your old card cage to the new card cage for your