Cisco 7513 Series Инструкции по замене Руководство - Страница 12

Просмотреть онлайн или скачать pdf Инструкции по замене Руководство для Сервер Cisco 7513 Series. Cisco 7513 Series 22 страницы. Chassis replacement
Также для Cisco 7513 Series: Краткое руководство по эксплуатации (44 страниц), Инструкции по замене Руководство (26 страниц), Информационный лист (11 страниц), Руководство (30 страниц), Поддержание (20 страниц), Инструкции по замене Руководство (19 страниц)

Replacing the Chassis

Installing the Cable-Management Bracket

Once you have rack-mounted the new chassis, follow these steps to install the cable-management

bracket:

Step 1

Step 2

Figure 6

Blower

module

Loosen

screws (2)

Bracket

Card cage

Step 3

Step 4

This completes the procedure for installing the cable-management bracket.

Proceed to the next section for the procedure for removing processor modules.

12 Cisco 7513 Chassis Replacement Instructions

At the interface processor end of the router, place the bracket above the card cage opening

and align the holes in the bracket with the holes in the chassis.

Insert the screws through the bracket and into the chassis. (See Figure 6.)

cable-Management Bracket

When both screws are inserted, use a ﬂat-blade screwdriver to tighten them.

When installing the network interface cables, route the cables to the cable-management

bracket, as shown in Figure 6. If you are using very thin cables that slip through the bracket

openings, insert cable ties through the holes in the bracket and wrap them around the cables

to secure them.

It might be necessary to bundle longer cables to avoid tangling them. Do this at the

cable-management bracket or at the rack, but leave enough room to be able to remove

processor modules and change cables as required. Also, do no block the power supply air

vents with cables.