Cisco APIC M4 Руководство по установке и обслуживанию - Страница 33

Просмотреть онлайн или скачать pdf Руководство по установке и обслуживанию для Сервер Cisco APIC M4. Cisco APIC M4 46 страниц.

Installing the Server

The following are the requirements for Strong Password:

• The password can have minimum 8 characters; maximum 14 characters.

• The password must not contain the user's name.

• The password must contain characters from three of the following four categories:

• English uppercase letters (A through Z)

• English lowercase letters (a through z)

• Base 10 digits (0 through 9)

• Non-alphabetic characters !, @, #, $, %, ^, &, *, -, _, =, "

Step 9

Continue with

Setting Up the System With the Cisco IMC Configuration Utility, on page

Setting Up the System With the Cisco IMC Configuration Utility

Before you begin

The following procedure is performed after you connect to the system and open the Cisco IMC Configuration

Utility.

Step 1

Set the NIC mode to choose which ports to use to access Cisco IMC for server management. Cisco IMC for APIC

appliance only supports dedicated mode:

• Dedicated—The dedicated management port is used to access Cisco IMC. You must select the None NIC redundancy

setting in the following step.

Step 2

Set the NIC redundancy to none, which is the only supported option for dedicated NIC mode:

• None—The Ethernet ports operate independently and do not fail over if there is a problem. This setting can be

used only with the Dedicated NIC mode.

Step 3

Choose whether to enable DHCP for dynamic network settings, or to enter static network settings.

Before you enable DHCP, you must preconfigure your DHCP server with the range of MAC addresses for

Note

this server. The MAC address is printed on a label on the rear of the server. This server has a range of six

MAC addresses assigned to Cisco IMC. The MAC address printed on the label is the beginning of the range

of six contiguous MAC addresses.

The static IPv4 and IPv6 settings include the following:

• The Cisco IMC IP address.

For IPv6, valid values are 1 - 127.

• The gateway.

For IPv6, if you do not know the gateway, you can set it as none by entering :: (two colons).

Setting Up the System With the Cisco IMC Configuration Utility

Cisco APIC M4/L4 Server Installation and Service Guide

29.