Installation Safety and Site Preparation
Required Tools and Equipment for Installation and Maintenance
1000BASE-X—1000 Mb/s full-duplex transmission over a Category 5 or better unshielded twisted-pair (UTP) cable
(IEEE 802.3z). Supports the Ethernet maximum length of 328 feet (100 meters).
1000BASE-T—1000 Mb/s full-duplex transmission over a Category 5 or better unshielded twisted-pair (UTP) cable
(IEEE 802.3ab). Supports the Ethernet maximum length of 328 feet (100 meters).
100BASE-TX—100 Mb/s full-duplex transmission over a Category 5 or better unshielded twisted-pair (UTP) cable
(IEEE 802.3u). Supports the Ethernet maximum length of 328 feet (100 meters).
Serial Connections
Before you connect a device to a serial port, you need to know the following:
Type of device, data terminal equipment (DTE) or data communications equipment (DCE)
Type of connector, male or female, required to connect to the device
Signaling standard required by the device
These are the most common devices connected to the router serial ports:
Serial Devices
Devices such as RTU or
IED with serial
asynchronous interface
Note:
No synchronous
serial protocol support
Connecting
You must provide or purchase separately the correct serial cable. The cable does not ship with the router. Contact
your Cisco reseller to purchase the correct cable from Cisco.
You can connect a device to this port while the router is operating normally.
The serial ports are labeled SER 1/1 and SER 1/2.
Related Information
For more information about this port, including supported standards and signaling, see
page
11.
Asynchronous Module Baud Rates
Maximum baud rate for asynchronous interfaces is 115.2 kbps.
Required Tools and Equipment for Installation and Maintenance
You need the following tools and equipment to install and upgrade the router and its components:
ESD-preventive cord and wrist strap
Network Options
CGR 1120 serial interface
can connect through DB9
connector devices with
RS232 and RS485
asynchronous full-duplex
or half-duplex support
Network Protocols
IP over SLIP or PPP
asynchronous lines
Raw Socket and SCADA
protocol translation
(DNP3 to DNP3/IP and
IEC 60870-5-101 to
IEC 60870-5-104)
9
Network Topology
Point-to-Point
Router Hardware Description,
Печатать страницу