B2 Audio RAGE1200.6 Руководство пользователя - Страница 4
Просмотреть онлайн или скачать pdf Руководство пользователя для Усилитель B2 Audio RAGE1200.6. B2 Audio RAGE1200.6 13 страниц.
Печатать страницу
Panel layout
L-CH
INPUT
R-CH
INPUT
RCA signal input for left & right channel.
A minimum of 0.2V input signal is required for correct
operation. Using only 1 input will minimize input signal
and ampli er will need to be gained as such.
subsonic
Variable subsonic setting from 10 Hz to 50 Hz.
It is highly recommended to set it according to the tuning
of your subwoofer enclosure to avoid unnecessary strain to
your sound system.
LPF (LOW PASS FILTER 35 Hz ~250 Hz, 24 dB/oct)
Adjusts the cut o point for the low pass crossover at the
chosen frequency.
Master / slave
Master & slave settings enables strapping of the ampli er
with another identical ampli er to achieve twice the power.
When set in master, this unit will be sending the signal to
the slave unit from the master out rca. The slave ampli er
will have the switch set to slave. The rca input shall be
connected to the "slave in" input which comes from the
master out position from the master amp.
BASS
GAIN SUBSONIC
BOOST
5V 0.2V 10Hz
50Hz 0dB
9dB
REMOTE
4
MASTER SLAVE
SLAVE-IN
LPF
PHASE
35Hz 250Hz 0
180
O
O
MASTER-OUT
gain (5v ~0.2V)
Adjusts signal input voltage from the input source to
match the ampli ers input stage. 0.2V ~5V is the operational
voltage. Voltages beyond may cause errors or damages to
the input section.
Bass boost
Level control of 0~9 dB @ 45 Hz.
REmote level control port
Connection of external signal level control with clip
indicator. Caution, it is not a volume knob and shall be
adjusted in accordance with the ampli ers gain.
Phase
Variable phase adjustment from 0 ~ 180
Led status
Power lit = normal operation, Clip lit or ashing = signal
input is not clean and distortion is detected.
Protect = ampli er has shut down operation caused by
error, user failure or damage.
POWER
CLIP
PROTECT
o