Cisco SNS-3415 series Руководство по установке - Страница 27

Просмотреть онлайн или скачать pdf Руководство по установке для Сервер Cisco SNS-3415 series. Cisco SNS-3415 series 36 страниц. Sns-3400 series
Также для Cisco SNS-3415 series: Руководство по установке (19 страниц), Руководство по устранению неполадок (8 страниц)

Install the Cisco SNS 3415 and Cisco SNS 3495 Hardware Appliances

c) Push in the plastic release clip on each inner rail (labelled PUSH), and then continue pushing the server into the rack

until its front latches engage the rack posts.

Step 4

(Optional) Attach the cable management arm (CMA) to the rear of the slide rails. See

Arm (Optional), on page 23

Step 5

Continue with the "Connecting and Powering on Cisco SNS-3415/3495 Appliance".

Install the Cable Management Arm (Optional)

You can attach the cable management arm (CMA) to the rear of the slide rails.

The CMA is designed for mounting on either the right or left slide rails. These instructions describe an

Note

installation to the rear of the right slide rails, as viewed from the rear of server.

Step 1

With the server pushed fully into the rack, slide the plastic clip on the inner CMA arm over the flange on the mounting

bracket that attached to the side of the server. See the following figure.

Note: Whether you are mounting the CMA to the left or right slide rails, be sure to orient the engraved marking,

Note

"UP" so that it is always on the upper side of the CMA. See the following figure.

Step 2

Slide the plastic clip on the outer CMA arm over the flange on the slide rail. See the following figure.

Step 3

Attach the CMA retaining bracket to the left slide rail. Slide the plastic clip on the bracket over the flange on the end of

the left slide.

Figure 6: Attaching the Cable Management Arm (Rear of Server Shown)

for information.

Cisco SNS-3400 Series Appliance Hardware Installation Guide

Install the Cable Management Arm (Optional)

Install the Cable Management