Cisco SNS-3595-K9 Установка программного обеспечения - Страница 25
Просмотреть онлайн или скачать pdf Установка программного обеспечения для Сервер Cisco SNS-3595-K9. Cisco SNS-3595-K9 38 страниц.
Также для Cisco SNS-3595-K9: Руководство по установке (36 страниц)
Печатать страницу
Install Cisco ISE Software on Cisco SNS Appliances
Setup CIMC Configuration Utility
The following procedure is performed after you connect to the system and open the Cisco IMC Configuration
Utility.
Step 1
Set NIC mode and NIC redundancy:
a) Set the NIC mode to choose which ports to use to access Cisco IMC for server management:
• Shared LOM EXT (default)—This is the shared LOM extended mode, the factory-default setting. With this
mode, the Shared LOM and Cisco Card interfaces are both enabled.
In this mode, DHCP replies are returned to both the shared LOM ports and the Cisco card ports. If the system
determines that the Cisco card connection is not getting its IP address from a Cisco UCS Manager system
because the server is in standalone mode, further DHCP requests from the Cisco card are disabled. Use the
Cisco Card NIC mode if you want to connect to Cisco IMC through a Cisco card in standalone mode.
• Shared LOM—The 1-Gb Ethernet ports are used to access Cisco IMC. You must select a NIC redundancy
and IP setting.
• Dedicated—The dedicated management port is used to access Cisco IMC. You must select a NIC redundancy
and IP setting.
• Cisco Card—The ports on an installed Cisco UCS virtual interface card (VIC) are used to access the Cisco
IMC. You must select a NIC redundancy and IP setting.
See also the required VIC Slot setting below.
• VIC Slot—If you use the Cisco Card NIC mode, you must select this setting to match where your VIC is
installed. The choices are Riser1, Riser2, or Flex-LOM (the mLOM slot).
• If you select Riser1, slot 1 is used.
• If you select Riser2, slot 2 is used.
• If you select Flex-LOM, you must use an mLOM-style VIC in the mLOM slot.
b) Use this utility to change the NIC redundancy to your preference. This server has three possible NIC redundancy
settings:
• None—The Ethernet ports operate independently and do not fail over if there is a problem. This setting can
be used only with the Dedicated NIC mode.
• Active-standby—If an active Ethernet port fails, traffic fails over to a standby port.
• Active-active—All Ethernet ports are utilized simultaneously. The Shared LOM EXT mode can have only
this NIC redundancy setting. Shared LOM and Cisco Card modes can have both Active-standby and
Active-active settings.
Step 2
Choose whether to enable DHCP for dynamic network settings, or to enter static network settings.
Note
Before you enable DHCP, you must preconfigure your DHCP server with the range of MAC addresses for
this server. The MAC address is printed on a label on the rear of the server. This server has a range of six
MAC addresses assigned to Cisco IMC. The MAC address printed on the label is the beginning of the range
of six contiguous MAC addresses.
Setup CIMC Configuration Utility
Install Cisco ISE Software on Cisco SNS Appliances
25