Cisco UCS B200 M4 Указания по установке и обслуживанию - Страница 8

Просмотреть онлайн или скачать pdf Указания по установке и обслуживанию для Сервер Cisco UCS B200 M4. Cisco UCS B200 M4 30 страниц. For e5-2600 v4 series cpus
Также для Cisco UCS B200 M4: Указания по установке и обслуживанию (46 страниц), Руководство по обновлению (9 страниц), Руководство по обслуживанию (24 страниц)

Before upgrading or adding an HDD to a running system, check the service profile in Cisco UCS Manager and make sure the new

hardware configuration will be within the parameters allowed by the service profile.

Caution

To prevent ESD damage, wear grounding wrist straps during these procedures and handle modules by the

carrier edges only.

RAID Considerations

If the drive being replaced was part of a RAID array, Cisco recommends using a new drive of identical size, model, and manufacturer

to replace the failed drive. This recommendation comes from the industry standard practice of using drives of the same capacity when

creating RAID volumes. If drives of different capacities are used, the useable portion of the smallest drive will be used on all drives

that make up the RAID volume.

If you need to move a RAID volume from one server to another, both the old and new servers for the cluster must use the same LSI

controller. For example, migrating from a server with an LSI SAS1064E controller (B200 M2) to a server with a LSI SAS2008

MegaRAID controller (B200 M3) is not supported. Similarly, migrating a RAID controller volume from a UCS B200 M4 to a UCS

B420 M3 is not supported. However, migrating the RAID volume with LSI controllers is supported if you are migrating from a UCS

B200 M3 to a UCS B200 M4 blade server and running one of the following operating systems: RHEL 6.5, RHEL 7.0, Windows

Server 2012, and Windows Server 2012 R2.

For hard disk and RAID troubleshooting information, see the

Installing a Blade Server Hard Drive

Procedure

Step 1

Place the hard drive lever into the open position by pushing the release button.

Figure 6: Installing a Hard Drive in a Blade Server

Step 2

Gently slide the hard drive into the opening in the blade server until it seats into place.

Step 3

Push the hard drive lever into the closed position.

Cisco UCS Manager B-Series Troubleshooting

Guide.