Cisco UCS B250 M2 Указания по установке и обслуживанию - Страница 31
Просмотреть онлайн или скачать pdf Указания по установке и обслуживанию для Сервер Cisco UCS B250 M2. Cisco UCS B250 M2 34 страницы. Extended memory blade server
Печатать страницу
S e n d d o c u m e n t c o m m e n t s t o u c s - d o c f e e d b a c k @ c i s c o . c o m
A UCS B250 Extended Memory Blade Server can hold two Virtual interface cards of the same type, and
as of UCS Manager 1.3(1) you can mix supported Virtual interface cards with either M72KR-E or
M72KR-Q (other combinations are not supported).
If you are switching from one type of adapter card to another, before you physically perform the switch
make sure you have downloaded the device drivers that match your version of UCS Manager and loaded
them into the server's OS. For details refer to the firmware management chapter of one of the UCS
Manager software configuration guides. The firmware version for the adapter must match the version of
UCS Manager used, and the adapter card must be supported in the UCS Manager version your system
uses.
To deploy two Virtual Interface Cards on the UCS B250 Extended Memory Blade Server running ESX
Note
4.0, you will need to upgrade to patch 5 (ESX4.0u1p5) or later release of ESX 4.0.
To remove an adapter card from the extended memory blade server, follow these steps:
Loosen the three captive screws shown in
Step 1
Remove the adapter connector from the motherboard connector and pull straight up. Be careful not to
Step 2
damage the connectors.
Figure 16
To install an adapter card on the extended memory blade server, follow these steps:
Position the adapter board connector above either mother board connector and align the three adapter
Step 1
captive screws to the posts on the motherboard.
Firmly press the adapter connector into the motherboard connector. If the seating is bad, it may cause
Step 2
the network connection LED to stay amber when the server is restarted.
OL-22474-03
Figure
Installing an Adapter Card
Cisco UCS B250 Extended Memory Blade Server Installation and Service Note
16.
Memory and Performance
31