Cisco UCS B260 M4 Указания по установке и обслуживанию - Страница 34
Просмотреть онлайн или скачать pdf Указания по установке и обслуживанию для Сервер Cisco UCS B260 M4. Cisco UCS B260 M4 50 страниц. Blade server
Также для Cisco UCS B260 M4: Указания по установке и обслуживанию (46 страниц)
Печатать страницу
Installing Memory
Figure 15: Thermal Grease Application Pattern
Step 10
Replace the heat sink. See callout 4.
Caution
Step 11
Secure the heat sink to the motherboard by tightening the four captive screws a quarter turn at a time in an X
pattern as shown in the upper right.
Installing Memory
To install a DIMM into the blade server, follow these steps:
Procedure
Step 1
Press the DIMM into its slot evenly on both ends until it clicks into place.
DIMMs are keyed. If a gentle force is not sufficient, make sure the notch on the DIMM is correctly aligned.
Note
Step 2
Press the DIMM connector latches inward slightly to seat them fully.
Supported DIMMs
The DIMMs supported in this blade server are constantly being updated. A list of currently supported and
available DIMMs is in the specification sheets at:
Cisco UCS B260 M4 and B460 M4 Blade Server Installation and Service Note for Servers with E7 v3 and E7 v2 CPUs
26
On certain models, heat sinks are keyed to fit into the plastic baffle extending from the motherboard.
Do not force a heat sink if it is not fitting well, rotate it and re-orient the heat sink.
Be sure that the notch in the DIMM aligns with the slot. If the notch is misaligned you may damage
the DIMM, the slot, or both.
Servicing the Blade Server