Cisco ASR 9000 Series Руководство - Страница 30
Просмотреть онлайн или скачать pdf Руководство для Шлюз Cisco ASR 9000 Series. Cisco ASR 9000 Series 44 страницы. Line card
Также для Cisco ASR 9000 Series: Настройка параметров сети (26 страниц), Руководство по конфигурации (46 страниц), Руководство по конфигурации (50 страниц), Руководство (24 страниц), Настройка (46 страниц), Краткое справочное руководство (7 страниц)
- 1. Field Replaceable Units
- 2. Online Insertion and Removal
- 3. Powering off the Router
- 4. Replacing the Chassis Air Filter
- 5. Required Tools and Equipment
- 6. Removing a Fan Tray
- 7. Installing a Fan Tray
- 8. Disconnecting AC Power
- 9. Reconnecting AC Power
- 10. Disconnecting DC Power
- 11. Reconnecting DC Power
Migrating from RP2 to RP3 Card
Step 13
Insert and boot RP2. After booting, the RP2 becomes standby RP. Do not set the ROMMON variable.
Step 14
Repeat Step 7, Step 8 and Step 9.
Step 15
(Optional) Perform FPD upgrade on the RP2. Use these commands:
Example:
Router#(admin) upgrade hw-module fpd all location 0/rsp0/cpu0
Router#(admin) upgrade hw-module fpd all location 0/rsp1/cpu0
Step 16
Clear ROMMON variable for active RP from XR prompt:
Example:
Router# run nvram_rommonvar RSP_LINK_1G 0
Migrating from RP2 to RP3 Card
Before you begin:
• You must have console access to the router. Default console speed on RP3 is set as 115200.
• The router must be running Cisco 64-bit IOS XR software release 6.5.15 or later version. If your router
• The router must have two RP2 cards (active and standby) up and running.
• First and second generation Cisco ASR 9000 Ethernet Line Cards must be removed from the chassis as
Procedure
Step 1
Use the show redundancy summary command to verify that the RP0 and RP1 are in Ready State.
Example:
Router# show redundancy summary
Active/Primary Standby/Backup
-------------- --------------
0/RP0/CPU0(A)
0/RP0/CPU0(P)
Step 2
Shutdown the standby RP2 card (slot 1) using the admin hw-module shutdown location 0/RP1 command.
Replacing Cisco ASR 9000 Series Router Components
30
is running a 32-bit IOS XR release, you will need to migrate to 64-bit XR release 6.5.15 or later. Refer
to
Migration Guide for Cisco ASR 9000 Series
Note
RP3 is only supported with 64-bit IOS XR software releases.
they are incompatible with RP3.
0/RP1/CPU0(S) (Node Ready, NSR: Ready)
0/RP1/CPU0(B) (Proc Group Ready, NSR: Ready)
Replacing Cisco ASR 9000 Series Router Components
Routers.