Cisco Catalyst 8200 Series Краткое руководство по эксплуатации - Страница 3
Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Шлюз Cisco Catalyst 8200 Series. Cisco Catalyst 8200 Series 8 страниц. Installing andupgrading field replaceableunits
Печатать страницу
Installing and Upgrading Field Replaceable Units
Figure 2: Disconnecting SFP Latch Mechanisms
1
Sliding latch
2
Swing and slide latch
Use a pen, screwdriver, or other small straight tool to gently release a bale-clasp handle if you cannot reach it
Tip
with your fingers.
Step 4
Grasp the SFP on both sides and remove it from the device.
Removing and Replacing the Chassis Cover
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement
1030
These are the steps to remove the chassis cover:
1. Confirm that the chassis is turned off and disconnected from the power supply or power supplies.
2. Place the chassis on a flat surface.
3. Remove the screws at top of the chassis cover.
4. Remove one screw from each side of the device as shown in the following figure.
3
Bale-clasp latch
4
Plastic collar latch
Removing and Replacing the Chassis Cover
Installing and Upgrading Field Replaceable Units
3