Cisco EVM-IPVS-16A Подключение - Страница 6

Просмотреть онлайн или скачать pdf Подключение для Шлюз Cisco EVM-IPVS-16A. Cisco EVM-IPVS-16A 15 страниц. Analog video gateway network modules

How to Install, Connect, or Replace the EVM-IPVS-16A Network Module

•

Installing the EVM-IPVS-16A Network Module in the Router Chassis

To install the EVM-IPVS-16A network module in the router chassis, see the Installing Cisco Network

Modules in Cisco Access Routers guide at:

http://www.cisco.com/en/US/docs/routers/access/interfaces/nm/hardware/installation/guide/InstNetM.

html

The EVM-IPVS-16A network module can only be installed in slots that support extension modules. For

Note

information about which slots support extension modules, see

Wire the provided terminal block connectors using the pinout information provided in

Figure

The wires used to connect to the terminal block are required to be between 26 AWG and 18 AWG.

Note

Figure 4

Table 4

When you wire the terminal block connector, label each wire with the pin number, so you can easily

Tip

connect the wires to the alarm or RS-485 devices in your network.

Connecting Cisco Analog Video Gateway Network Modules to the Network

Performing Online Insertion and Removal of the EVM-IPVS-16A Network Module, page 10

4.)

Wiring the Terminal Block Connectors

lists each pin on the terminal block, and the corresponding port information.

Connecting Cisco Analog Video Gateway Network Modules to the Network

Table 1-1 on page 5

Table

4. (See